Thursday 19 March 2015

Solid Edge Video Quick Tip # 027

Partial holes should be avoided since drill may wander if a large portion of the hole is outside the material.

01
When you have imported geometry with features not matching your machining standards you can use Solid Edge Synchronous Technology to rectify such situations.

Switch the imported model to synchronous mode and apply dimensions to imported geometry. These dimension will drive features as if created natively.

Pay attention to which face will be moved by the dimension change. The following video demonstrates this:

C l i c k  H e r e  t o  V i e w  F u l l - S c r e e n  V i d e o  o n  Y o u T u b e

(www.SurfAndCode.in) Solid Edge Video Quick Tip #027


Index of all Solid Edge Tips, Tutorials and Videos...


No comments:

Post a Comment