Thursday, 13 February 2014

Solid Edge SheetMetal Workshop 5

Step 5 :

Click on the other side to complete the line as shown in figure below :

clip_image002

Note : You may draw line as horizontal or inclined.

Click on the Finish button in the upper-left corner of the screen.

Step 6 :

Click on the farther side to indicate the side to bend as shown in figure below :

clip_image004

Step 7 :

Click on the uupper side to indicate the direction to bend as shown in figure below :

clip_image006

The sheetmetal stock part will be bent along the drawn line as shown in figure below :

clip_image008

If you draw the line parallel to one of the sides, the result will be as below :

Also note the automatic creation of the rounds where the part bends in both cases.

clip_image010

Step 8 :

Click the Drawn Cutout clip_image012 command.

Click on the top face of the part.

Create a rectangle as you have done in Step 4 of Work Shop 1

clip_image014

Click Finish in the upper-left corner of the screen

Using the mouse cursor, indicate the depth and direction as shown below :

clip_image016

Index of Solid Edge Articles/Tips/Tutorials on this blog is here.